- Beiträge: 9
- Dank erhalten: 2
Die Bosch D-Jetronic war 1967 die erste Großserien elektronische Einspritzung der Welt. - Bosch's D-Jetronic was the first mass-production electronic fuel injection.
Warm start issue
- Cptkeesman
- Autor
- Offline
- Frischling
-
Weniger
Mehr
2 Jahre 5 Monate her #18794
von Cptkeesman
Warm start issue wurde erstellt von Cptkeesman
Hi All
i have a 450SL Djetronic USA
After a lot of work it runs OK now and emission is OK too
however
when it starts with warm motor, like a stop to refuel, the engine will start, idle OK, but badly respond to accelarator, it will backfire and fart
this lasts for a minute or so, sometimes it dies out
After this it goes back to normal
cold start is OK
any idea of what this can be?
rg
Kees
i have a 450SL Djetronic USA
After a lot of work it runs OK now and emission is OK too
however
when it starts with warm motor, like a stop to refuel, the engine will start, idle OK, but badly respond to accelarator, it will backfire and fart
this lasts for a minute or so, sometimes it dies out
After this it goes back to normal
cold start is OK
any idea of what this can be?
rg
Kees
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- nordfisch
-
- Abwesend
- Platin
-
Weniger
Mehr
- Beiträge: 2610
- Dank erhalten: 748
2 Jahre 5 Monate her - 2 Jahre 5 Monate her #18795
von nordfisch
nordfisch antwortete auf Warm start issue
Hi Kees and Welcome to the forum,
you should check the system holds fuel pressure after engine shutoff.
The system should hold most of the pressure for a longer period.
Maybe one ore more injectors or the cold-start valve are dripping.
Regards
Norbert
you should check the system holds fuel pressure after engine shutoff.
The system should hold most of the pressure for a longer period.
Maybe one ore more injectors or the cold-start valve are dripping.
Regards
Norbert
Letzte Änderung: 2 Jahre 5 Monate her von nordfisch.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- Cptkeesman
- Autor
- Offline
- Frischling
-
Weniger
Mehr
- Beiträge: 9
- Dank erhalten: 2
2 Jahre 5 Monate her #18796
von Cptkeesman
Cptkeesman antwortete auf Warm start issue
Hi Norbert
All injectors were revised in sets and did not change the issue
Will try to measure fuel injector manifold pressure after shut down and pump off
Will let you know
Thanks
All injectors were revised in sets and did not change the issue
Will try to measure fuel injector manifold pressure after shut down and pump off
Will let you know
Thanks
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- Dr-DJet
-
- Offline
- Moderator
-
- Dr-DJet repariert und sammelt alles! :-)
2 Jahre 5 Monate her #18798
von Dr-DJet
Viele Schraubergrüße - best regards, Dr-DJet Volker
Alles für den Mercedes-Benz R/C 107 und W116 in der SLpedia Sternzeit 107
Workshops D-Jetronic 28.6.(F),20.9.(ER), K-Jetronic 23.8.(F)
Dieses Bild ist für Gäste verborgen.
Dr-DJet antwortete auf Warm start issue
Or non-return valve on fuel pump.
Viele Schraubergrüße - best regards, Dr-DJet Volker
Alles für den Mercedes-Benz R/C 107 und W116 in der SLpedia Sternzeit 107
Workshops D-Jetronic 28.6.(F),20.9.(ER), K-Jetronic 23.8.(F)
Dieses Bild ist für Gäste verborgen.
Bitte anmelden oder registrieren um das Bild zu sehen.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
Ladezeit der Seite: 0.134 Sekunden