Injectors doesn't inject

Hi Ward,

that could be correct. It means that the ECU can generate injection pulses and ground connection is there. Now please remove fuel pump relay and pin 1 on ignition coil and measure pin 3,4,5,6 again whuile cranking the engine. Both tests can operate without a MAP sensor. Then verify that you see 90Ohm / 360 Ohm on MAP sensor from ECU connector (ECU disconnected) and check that there is no ground connection.

Does your car start and immediately stop again?

I've got my injectors injecting.
I think it was a combination of problems.
First there was bad wiring of the MAP-sensor (I didn't measured any resistance at the ECU) and injectors ( some injectors had a interruption in the wiring),
Also there was one injector that was stuck. I've cleaned them all in a ultrasonic cleaner.
After this all, my injectors are injecting again.
Thanks to all, for helping me out!

Hi Ward,

thanks for updating us. And yes wiring harnesses more and more become a problem.